Alderlea T5 Especificações descarregar pdf (Página 11)

Installation Procedure – Mobile Home

CAUTION: THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL

AND CEILING/ROOF MUST BE MAINTAINED.

Note: See "Combustion Air" section on page 11

1. Position stove and  oor protection with hole for combustion air in accordance with the

clearances as stated on the label and in Figure #3.

2. Mark the position for the hole in the ceiling and roof by using a string and plumb-bob.

3. Check that the intended location will not interfere with  oor joists, ceiling joists or rafters

before proceeding further.

4. Cut a hole in the ceiling and roof to suit the chimney system and frame in the sides. The

chimney support is mounted to the framing.

5. Assemble chimney sections so the  nished length is resting on the support and protruding

through the roof. Avoid having joints between ceiling and roof. Install radiation shield.

Assemble  ashing and storm collar and be sure to maintain the vapour barrier at this

point. (Seal securely.) Attach rain cap and check  ashing for leaks.

5. Install connector as per manufacturer's instructions.

6. To attach stove to  oor,  rst remove the leveling bolts from the legs. Then attach stove

to  ooring using two 1/4" x 2" or longer lag screws through the leveling bolt holes.

Follow chimney and chimney

components manufacturer’s

instruction for assembly and

installation.

081112-24 ALT5

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sem comentários

Alderlea T5 Especificações Página 11